JP1 Remotes

I recently bought a used GTP-500 with no remote included and I would really like some help from you guys here please.

I have a Vizio vur8 remote and it has a jp1.3 6 pin on the back.

I tried several things like the 990 and 991 commands but did not work, please help.

Use Setup code Audio 1530 and the EFCs listed in this older thread about the GTP-500. Note that the GTP-500II uses a different IR protocol, so make sure that you've got a 500.

To add the EFCs to your VUR8, use the 994 command.
1) Tap the Audio button
2) Hold the Setup button until 2 blinks
3) Enter 994
4) Tap Setup (don't hold it)
5) Enter the 5 digit EFC
6) Tap the button you want to assign the function to.
The remote should blink twice.

Here are the codes:

00240 = 1
00080 = 2
00144 = 3
00017 = 4
00006 = 5
00030 = 6
00238 = 7
00034 = 8
00242 vol up
00082 vol down
00015 Power
00142 Source
00078 FM/AM
00146 Tune Up
00019 Tune Down

3FG wrote:Use Setup code Audio 1530 and the EFCs listed in this older thread about the GTP-500. Note that the GTP-500II uses a different IR protocol, so make sure that you've got a 500.

To add the EFCs to your VUR8, use the 994 command.
1) Tap the Audio button
2) Hold the Setup button until 2 blinks
3) Enter 994
4) Tap Setup (don't hold it)
5) Enter the 5 digit EFC
6) Tap the button you want to assign the function to.
The remote should blink twice.

First of all I want to thank you guys very much for your help. Second, I'm a bit embarrassed but how do I input setup code Audio 1530? Do I need a jp1 cable?

Press Audio. Press setup until 2 blinks. Enter 31530. The remote should blink twice.

Thank you guys so much! I got it working! ...(except for the power button)

Very interesting stuff, I had no idea just how many can be done with an old remote. Awesome!

Please direct me where i can send a small donation to this site through PayPal in my appreciation for your help.

Here's a user manual, in case it helps
http://pdfstream.manualsonline.com/b/b7 ... 3f99fb.pdf