JP1 Remotes

Hi!

I came here looking to control my Honeywell HS-1665 fan for which I lost the remote.

A web search showed that this site has a thread and an uploaded file for a Honeywell fan so I thought I'd check it out and perhaps see if I could use it as a starting point for finding the codes for my fan.

I do not have a JP1, but I can program a microcontroller and blink an IR LED if I know what the timings need to be.

In this uploaded file:

https://www.hifi-remote.com/forums/dload ... ile_id=234

there is an excel spreadsheet with some IR codes in column A which look like "1F 00 00 00" and "1F 2C 55 00", etc. From other files in that archive I gather that the modulation frequency is 38 KHz.

So I just need some pointers on how to translate the sequence "1F 2C 55 00" into blinks of an IR LED.

Thanks!

If you're going to write code for a microcontroller, would I be right in assuming you have at least a basic knowledge of what remote control IR signals look like? And if so, are you familiar with Pronto Hex?

If you answered no to either of those questions, I don't think you can do this task and it would be much easier to just buy a JP1 remote and load the upgrade into it.

If you answered yes to both of those questions, there is Pronto hex in the spreadsheet that you downloaded, that should be all you need to recreate the signals.

Thanks for the information. I am familiar with the structure of IR codes and the information given in the Pronto Hex page.

So now my question is how would I find the timing data for the various kinds of bursts, e.g. the lead-in burst, logical 1, logical 0, lead-out burst? Is it perhaps in one of the .txt files in the archive or the IR-Honeywell.ir file somewhere?

Thanks again!

That information is all built into the Pronto hex. If you look at the "Decodes from CCF file" tab, the upper section is the raw Pronto hex and the lower section is the timing data, and it's derived from the Pronto hex using Excel formula.

Thanks for pointing out that tab - I completely missed it!