JP1 Remotes

I'm just now getting my feet wet in extender-ville, and I'm having a problem with the volume+, volume-, and mute keys. When I press them, the LCD panel changes from AUDIO to SSEL, and the remote sends out Zenith commands rather than the ones I expect. Other audio keys seem to work fine. My IR file is here:

https://www.hifi-remote.com/forums/dload ... le_id=8865

Thanks for any help you can give!

Well, I know these remotes don't like invalid device setup codes, and you have 6 of them. Fix that first. And are you certain you actually activated the extender? If not, then you may see the volume punch thru behavior you're getting.

It also looks like you didn't start with a good download first. If I were you, I'd deactivate the extender, do a 981 reset and download. Then do extinstall and make your changes.

Thanks. New batteries and careful attention to making sure extender was activated solved the problem.

Next step is putting LKP macros on device buttons. Does anyone have any hints/pointers on this?

Is it necessary to activate separately each protocol in an extender, e.g., LKP, device multiplexer, etc., or does activating the extender activate everything?

You only need to activate the extender, nothing else.

jetstar52 wrote:Thanks. New batteries and careful attention to making sure extender was activated solved the problem.

Next step is putting LKP macros on device buttons. Does anyone have any hints/pointers on this?

I like to set all my key groups in the main macro first leaving the existing macro mostly as-is, then call my LKP macro (xshift-phantom1 for example). The short side is blank, and the long side does everything else. That way a short press still switches devices modes normally.

As an experiment, I'm trying to call "M1" as a long keypress on my TV button, but I'm getting no response. Here's the IR file:

https://www.hifi-remote.com/forums/dload ... le_id=8868

Thanks in advance, again.

Doesn't work that way. You can only have one macro per key, and you already have a TV macro. You have to use a different key. Add some unused key like phantom1 to the end of your tv macro on the macros tab, then change the target key from tv to phantom1 on the special protocols tab. Also, 5 is quite a long time. I usually set my LKPs to 2.

Thanks so much. It's working now. The "key" isn't the device key, but the last key in the macro that's already on the device key. You bind the LKP macro to that.