JP1 Remotes

Is there a discrete code for power off a bell express vu 3100 sat receiver?
The protocol I use in my remote is SAT/0775.
All I have found so far are these pronto code:

http://www.remotecentral.com/cgi-bin/fi ... ssreceiver


I'm not sure how to put this in my jp1 remote...

Carl wrote: I'm not sure how to put this in my jp1 remote...

You must have been away for a while. Graham (mathdon) has made some exciting changes to IR that make this a piece of cake.

Download the latest version or IR

If your remote has learning:
Open your IR image, naviagte to the learned signals Tab, and add the signals using the pronto hex option. Then test:

If your remote doesn't have learning.

Open a NEW image for any remote that has learning, add the signals and get the decode information that you need for KM or RM.

wow! It's working.I can now turn off my receiver with the pronto code.
I love this jp1 stuff!

There are a number of upgrades for Dish network receivers in the upgrades area, most of them have the discrete off and discrete on codes in them. (although with the latest receivers Select works as discrete on)

there are also some other undocumented codes as well, for example there is a code that gets straight to the system info menu which is sometimes useful. There are a number of us who have pretty much loaded every possible code into remotes and pointed them at the receivers to see what they do.

(interesting enough, there is a code that is sent that is the same as "info" but also tells some of the receivers to display "low battery" on the screen. The Dish remote must send that code when it senses the battery is low. I've often thought of writing a protocol that would send one of two codes depending on the battery state but never got around to it.

It's good to know.Thanx fo all the info.

I put all the Dish discretes I could find into THIS upgrade. In addition to the ones above, I found a new one that toggles between pip side-by-side and full screen.