JP1 Remotes

Hello, Im trying to program a comcast remote for the ilive itb283b sound bar, im struggling to find the correct codes, mainly vol+/-. Anyone able to help?

In order to provide EFCs we need to know which remote you have.

EFCs need to be calculated to work with a specific setup code.

ok, its the dark grey remote with the red ok/select button
the sticker in the battery compartment says

RC1475507/02B 16002
CIFA No. 27634
BS: 01 11111 020453

hope this helps

www.urcsupport.com says this is probably setup code Audio 2013. which is NEC1 device 255. Comcast remotes don't carry this setup code, and I don't believe that the Comcast remotes have any built in setup code that shoots this IR protocol.

i seen the previous post regarding the ilive itp280 and tried using those codes. the power code worked with a hitch, in order to turn on off the device i would have to hold the power button for a few seconds then tap it again quickly. unfortunately the vol+/- codes didnt work at all.

So post a link the "previous post" or at least tell which setup code works with power.

3FG, How did you figure out it was Comcast?

I believe JOOKZ is referring to this post for the itp283b code that work on NEC1 0 which calculated for

Video/1089
00052 Power
00167 vol up
00171 vol down

He says the power button works when he holds it and then taps and releases it.



I saw these were part of Walmart's Black Friday sale. Maybe sommeone will be posting an upgrade later this month. But if it is a 255, it will not be something he can add via EFC's

However since this does respond to Nec1 0 in some odd fashion, perhaps an EFC test on Video/1089 might yield some ifunctionality.

The EFC range for this is 00000-00255
Please post back if you have any success. All remotes tend to have some sort of Nec1 0 device, so this would be a huge help to everyone if you discover power, and volume.

The OP says "comcast".

Oh and to test those codes you don't need to assign them to the keys, you can just switch over to the device that has Video/1089 assigned and then tap setup followed by the code. Each time you press the final digit of the 5 digit EFC, point the remote at the device to be controlled and hold down that last digit.

3FG wrote:The OP says "comcast".

Oh, I didn't read the first post close enough. Didn't see the word comcast at all.

00116 vol+
00052 mute
00054 optical
00057 line
00123 bluetooth
00183 vol -

Thank you for giving back to the community by posting your results.
I created an upgrade from this partial list
https://www.hifi-remote.com/forums/viewtopic.php?t=1502