URC-8810 not learning

ianicbrisson · Post by **ianicbrisson** » Mon May 03, 2004 10:17 pm

I have tried learning another remote's functions on my URC-8810 but it did not work. All worked as planned up to the red led rapidly flashing, but it does not give the two blinks indicating that it's managed to learn the signal. I've tried it with two different source remotes and nothing. I've verified that it really didn't learn anything by uploading the results through IR; nothing.

I've actually never tried learning with this specific remote as I exchanged it one year ago returning an URC-8910 with the awfull disc. At the time, I had done all my learning with the URC-8910 so it's the first time I'm trying to use the learning capability of the URC-8810.

I opened the remote this week and noticed that in the upper area of the PCB a resistor was barely hanging on. when I looked closer, it fell off so I resoldered it. Since it's a tiny surface mount resistor, I doubt my repair job was very good but since all worked fine, I thought I had succeeded. Now that the learning is failing, I am not so sure.

Any body's got a take on this? Do you think the resistor is the culprit?

Thanks for any input.

Ianic

Nils_Ekberg · Post by **Nils_Ekberg** » Wed May 05, 2004 3:28 pm

My first thought is that yes, the resister may be the culprit but since it was loose it may also be a sign of some other damage. I would look close at the board on both sides and see if you can find any other damage or open circuits. You may have to test the circuits and resister with a meter to really tell.

There is even the possibility that the resister came loose from impact and could have been fried re-soldering it.

ianicbrisson · Post by **ianicbrisson** » Thu May 06, 2004 12:45 pm

I am sure the resistor did not come off because of an impact, the soldering pattern was clearly indicating a sloppy job. The resistor was actually "floating" on top of two small uneven solder slobs. On one side the solder was spicked and the resistor was sitting on the top of the spike.

I still scrutinised the whole board and there are no other signs of damage. I'll borrow a soldering station from work this weekend and try to fix it. I'll test the resistor at the same time to see if it's not fried.

Thanks

Ianic

Post by **The Robman** » Thu May 06, 2004 6:05 pm

When the rapid flashing starts, you are pressing the "teaching" button then right, you're not waiting for the flashing to stop before you start pressing?

ianicbrisson · Post by **ianicbrisson** » Fri May 07, 2004 8:00 am

Yes, I'm pressing the teaching button. When I reached this dead end, I pulled an old URC-7800 from a drawer where it was waiting to be repaired for a friend and I used it's learning capabilities and everything worked fine. Now the URC-7800 is gone and I don't have any learning capabilities anymore. I'll see if I have any success in my repair this weekend.

Ianic