Hello
I'm trying to program a valid code for my european devices. How can I use the IR port of my Pc to "capture" data codes of original remotes (with Girder...?)
Stefano
Vicenza, Italy
Learning codes through IR port
Moderator: Moderators
We're pretty good at interpreting the results of using Lirc to learn signals on a PC. I don't recall the status of attempts to do similar things with Girder.
The list of setup codes you mentioned in that other thread are mainly setup codes for protocols most of the experts here would not recognise. That complicates the task of looking at an unknown format for storing the signals (usually we figure out storage format issues by knowing the structure of the stored signal, or we figure out new signal structures by knowing the format they're stored in).
The list of setup codes you mentioned in that other thread are mainly setup codes for protocols most of the experts here would not recognise. That complicates the task of looking at an unknown format for storing the signals (usually we figure out storage format issues by knowing the structure of the stored signal, or we figure out new signal structures by knowing the format they're stored in).